To cement and respray painting on front cabin, inner and outer accident parts (2k paint).

To respray undercoat on the accident parts.

To respray corporate lining.

To write and draw the address and logo.

To check both wheel alignment.

To remove the damaged front windscreen glass and to refix the new windscreen glass supplied, adjusting, and realigning the windscreen glass framework.

To remove the complete dashboard panel, instrumental panel, steering shaft cover, driver seat, floor map, side panel, rubber map, windscreen glass pillar and to effect knocking the panel and refix same.

To hydraulic jack & straighten out the front LH & RH windscreen glass pillar and chisel out the pillar and replace with the new parts, cutting and welding and realign same.

To lift out the front cabin to realign, check the main chassis framework, and refix same.

To remove the inner and outer wiring system the main fuse box, dashboard cable harness, to effect repair the cabin and to refix the new parts supplied same.

To replace the damaged air hose, air brake hose, evaluate the brake system, and air system.

To complete remove the front & rear suspension system, steering system, wiring system, fuel tank and all accessories attach to the chassis frame to realign the chassis frame and refix same.

To complete remove the engine & transmission gear box and refix same.

To hydraulic jack and straighten the two main chassis frame and realign same.

To remove air-cond. system, blower, air-cond condenser and refix the new air-cond condenser, air-cond blower supplied and refill air-cond gas and test the air-cond system (R134).

To hydraulic jack the cabin chassis frame, chisel out the cabin chassis, engine casing panel and refix the new chassis frame and panel and plus welding.

To remove all damaged parts, to complete knock dented cabin, chisel out front panel & replace new panel, to realign cabin floorboard, hydraulic jack whole cabin to correct position, realign and reassemble same.

To refix the side door window mechanism, to check the wiring system to working condition.

To remove the nozzle, clean up the engine, start the engine, and calibrate the electronic system.